Contacts
Address
USA, Ohio, Akron, 44311-1899, 587 Baird St
Director
Charles Conner
Phones of enterprise
management
+1
When placing an order please inform the manager that you've learned the information on Allbiz! Thank you that you buy on Allbiz!
Internet
Site:
About enterprise
Alcon Tool Co, Company
Equipment - fabricated metal products other than machinery and transport equipment
In stock
These knives are used in pairs, one left hand and one right hand. They are made in Semi-High Speed grade only, and come in two basic configurations:
30 teeth/20º
31 teeth/17º
HOW TO ORDER:
Specify A, B, C, D, E and right or left hand, plus which configuration.
Group: Spare parts for machine-tools
In stock
Scallop Knives are made only in the Semi-High Speed grade of tool steel, and always to the customers specifications. The table below shows some of the common sizes made, but Alcon can manufacture scallop knives to any specifications you require.
HOW TO ORDER:
1) Select a pattern from the...
Group: Cutters
In stock
Perforating Knives are made to customer's order. Standard and Semi-High Speed grades are both available, so please specify grade desired when ordering.
HOW TO ORDER:
1) Give Alcon Tool #
2) Send sample, sketch or data to provide
dimensions: A, B, C, J, K and number of
teeth N
3) Or...
Group: Hammer drills
In stock
Alcon offers a wide selection of slitting knives to meet your needs. Most knives are available in two (2) grades of steel.
Alcon Standard Grade
AISI 52-100
Alcon Semi-High Speed
AISI 0-7
(see page 2)
Manufacturing...
Group: The equipment cutting
In stock
Alcon is one of the few companies equipped with the special set-ups required to properly regrind cutters such as these.
At Alcon, these cutters are reground - not annealed and remilled - because after one or two annealings and rehardening, the wheels will break.
Alcon guarantees that...
Group: Rings cutting
In stock
Precision Levers shown have A-2 tool steel hardened side plates, that are accurately ground after assembly. This is done to insure that the wheel will stand square to the roll, for straight, true cutting and long life.
Integral Levers are for use with a dovetail bar, and are easily...
Group: Cutting tool
In stock
To properly regrind thin edge knives, one must have:
1)
Soft wheels of the proper grit and grade. Alcon uses the following wheels:
7" x 1/2" x 1 1/4" 32A60 H 8VBE 3500 RPM
8" Cup wheels 32A46 G 8VBE 1800 RPM
2)
An understanding of the edge one...
Group: Choppers blenders
In stock
These knives were one of the first items that Alcon Tool supplied to the local rubber companies. Fortunately for both the rubber companies and Alcon, we are still making hundreds of Bias Cutter knives each day.
It is estimated that Alcon produces approximately 90% of these blades used in the...
Group: Metalcutting tools
In stock
Alcon Slitting Roll Sleeves are made from high carbon, chrome alloy steel, which hardens completely through the sections normally required for this service.
63-64 RC hardness is guaranteed. Repeated grinding will not expose soft areas, as is the case on sleeves which have been carburized or...
Group: Special cutting tool
In stock
Alcon's "Performance Plus" attitude is reflected in our line of disc knives. Our ability to manufacture thin disc knives of superior quality from many grades of tool steel sets us apart from other knife makers.
We use A-2 Tool Steel as our general purpose grade which is adequate for many...
Group: Knifes disk